6 new refurbished from 161 12.
2002 c230 light flashing after locking doors.
Is there a way to program the lock and alarm system to recognize the remote.
Updated 10 04 17 the consumer stated due to the steering lock failure the steering wheel moves freely while driving and parked.
By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.
Check central locking fuse.
Mercedes c230 2002 2005 door lock mechanism left driver side genuine fits.
The approximate failure mileage was 163 000.
Because your mb receives the lock unlock signal via the antennas installed on your car a bad antenna module fuse can also cause mercedes key.
Door lock was fixed and saved 270.
All three lights remain lit front side rear it would not likely be a brake light switch issue i believe.
When i came out later this afternoon i notice the hazard lights were flashing quite quickly.
3 29 2017 decatur ga the contact owns a 2002 mercedes benz c230.
Just stick a big paper clip and tape it.
For my 2002 c230k the remote transponder does not lock unlock doors or activate alarm.
Remove the metal key from the keyfob and use it to manually unlock the doors.
I unlocked the car using the key fob and got into the car however the dashboard didn t report anything.
2002 sl500 216 cl500 all fully loaded.
It does start car and lights up to show the new battery is good.
Thanks erik anderson email protected.
Its housed behind off side front wheel next to the door behind the shield that is the case on my e220cdi 20001 i am assuming its the same for all models but i could be wrong.
Indicators flashing after locking please help discussion in electrics vacuum ignition and.
I ve tried opening and closing all of the doors windows boot and bonnet and relocking the car etc but the hazards begin to continually flash again.
Next you need to check the fuse for the central locking circuit.
Not only that but also look at the fuse for the antenna module and aam.
I replaced my front door lock modules a couple of years back due to microswitch issues and have also done the turn signal stalk switch and flasher module about 3 years ago.